Bay Networks BayStack ARN Routers none Manuel de service télécharger pdf (Page 69)

Starting the ARN/DC

116273-B Rev 00

2-15

Enter the following command and press the Return key to run the

Quick-Start script:

run inst_arn.bat

The Quick-Start script begins running.

Using your completed Quick-Start worksheet from Appendix B, enter the

appropriate network information as the prompts appear.

The ARN/DC uses this information to configure interfaces to the network.

For sample Quick-Start screen output and for information on using

Quick-Start commands, see Appendix B.

Choose whether you want to configure another module/port.

Entering

n stops the Quick-Start script and returns you to the Technician

interface prompt. Entering

y allows you to configure another module/port.

Once the install script completes, the ARN/DC starts bridging and routing

traffic.

Ensure that the ARN/DC is successfully connected to your network.

To verify that the ARN/DC is now connected to the network, contact your

network administrator. To troubleshoot any problems, your network

administrator can refer to Configuring BayStack Remote Access.

If you need additional assistance, contact your local Bay Networks Technical

Solutions Center.

Note:

After connecting the ARN/DC to the network, you can replace the

management console connection with a modem connection to enable remote

dial-in access.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 151 152

Pas de commentaire

Bay Networks BayStack ARN Routers none Manuel de service Page 69