Bay Networks BayStack ARN Routers none Manuel de service télécharger pdf (Page 89)

Installing a WAN Adapter Module

116273-A Rev. 00

4-5

Removing an Adapter Module

To remove a WAN adapter module:

Using a Phillips screwdriver, remove the screw that secures the adapter

module you want to remove (Figure 4-3)

Figure 4-3. Removing the Adapter Module Screw

Pull the adapter module toward you to detach it from the base module

connector in the ARN/DC chassis.

Grasp the adapter module’s metal tab, or insert a thin tool (such as a flathead

screwdriver) in the slot on the tab.

Be prepared to apply some force, but stop pulling immediately once the

adapter module is free from the base module connector.

Slide the adapter module all the way out of the slot.

Place the adapter module in an antistatic bag.

Go to the next section, “Installing an Adapter Module.”

ISDN

DSU/CSU

ARN0033A

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 151 152

Pas de commentaire

Bay Networks BayStack ARN Routers none Manuel de service Page 89