Bay Networks 5000 Manuel de service télécharger pdf (Page 28)

Installing and Operating BayStack ARN Routers

1-6

114200-D Rev 00

Rack-Mounting the ARN

For this procedure, you need:

• Two flange brackets and eight #6 Phillips screws (shipped with the ARN)

• A Phillips screwdriver

• An electronic enclosure rack. If the rack does not have threaded rail holes, you

must attach the four cage nuts shipped with the ARN.

• Four #10 cagenut screws and washers (shipped with the ARN)

To rack-mount the ARN:

Determine how you want the ARN to fit in the equipment rack.

Multiple holes in the flange brackets provide several options for

rack-mounting the ARN. How you attach the flange brackets determines how

far the router extends outside or remains inside the rack. Figure 1-2

shows

three of the most common locations for the brackets.

Attach a flange bracket to each side of the ARN.

Align four bracket holes with four holes in the ARN enclosure

(Figure 1-2)

Insert a #6 Phillips screw through each hole and into the ARN.

Tighten the four screws with a Phillips screwdriver.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 165 166

Pas de commentaire

Bay Networks 5000 Manuel de service Page 28