Bay Networks 5000 Manuel de service télécharger pdf (Page 95)

Installing a WAN Adapter Module

114200-D Rev 00

4-7

Push the adapter module in until its connector pins align with the base

module connector socket in the ARN chassis.

Using a Phillips screwdriver, insert and tighten the screw (Figure 4-6).

Figure 4-6. Securing the Adapter Module to the Front Panel

Remove the antistatic wrist strap.

Connect the appropriate WAN cabling to the new interface.

For cabling information, see the module-specific Supplement and the Bay

Networks Cable Guide.

Turn power on, and check the diagnostic LEDs on the front panel of the

base module.

See “Ensuring a Successful Installation” in Chapter 3.

If the module fails its diagnostic test, the Fail LED remains on and the module

LED flashes rapidly.

Note:

See your module-specific Supplement for information about the LEDs

on the newly installed module. The new module’s LEDs will not indicate data

transfer until you have configured and enabled software services.

ISDN

DSU/CSU

ARN0033A

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 165 166

Pas de commentaire

Bay Networks 5000 Manuel de service Page 95