Bay Networks CM 100 Manuel d'instructions télécharger pdf (Page 41)

Getting Started

893-00992-A 1-7

Conﬁguration and Switch Management

The BayStack 350T switch is shipped direct from the factory ready to operate in

any 10BASE-T or 100BASE-TX standard network. You can manage the switch

with Optivity

network management software, or with any generic SNMP-based

network management software; however, you must assign an IP network address

to the switch. You can set the BayStack 350T IP address by using the service port

or by using the BootP protocol resident in the BayStack 350T switch. For more

information about using the service port for manual conﬁguration of the switch,

see Chapter

3, “Using the Console Interface.”

Network Conﬁguration

The BayStack 350T switch can be connected to workstations and personal

computers (PCs) either directly, through a hub, or through the creation of

virtual LANs (VLANs). This section shows three network examples using the

BayStack 350T switch in the following conﬁgurations:

• Desktop connections for power workgroups

• Desktop connections for power workgroups and shared media hub

• Virtual LAN workgroups

BOOK.MKR Page 7 Tuesday, March 4, 1997 7:24 PM

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 139 140

Pas de commentaire

Bay Networks CM 100 Manuel d'instructions Page 41