Bay Networks CM 100 Manuel d'instructions Page 89

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 140
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 88
Using the Console Interface
893-00992-A 3-27
The Port Configuration screen contains the fields listed in Table 3-7.
Table 3-7. Port Configuration screen fields
Field Description
Port The Port heading indicates the switch port numbers, from 1 through 16, that correspond
to the field settings in that row of the screen (for example, the field settings configured in
row 2 apply to switch port 2). Note that settings configured in the All row (bottom row)
affect all 16 switch port settings.
Status This field allows you to disable, through management, any or all of the switch ports. You
can use this feature to control access to any switch port.
Default Value: Enabled
Range: Enabled, Disabled
Link The Link field is a read-only field that indicates the present link state of the corresponding
port, as follows:
Up—The port is connected and operational.
Down—The port is not connected or not operational.
Auto
Negotiation
When enabled, this field sets the corresponding port speed to match the best service
provided by the connected station, up to 100 Mb/s at full-duplex mode.
Default Value: Enabled
Range: Enabled, Disabled
Speed/Duplex This field can be set to manually configure any port to support 10 or 100 Mb/s Ethernet
speeds, at half- or full-duplex mode.
Range: 10 Mb/s / Half, 10Mbs / Full, 100Mbs / Half, 100Mbs / Full
BOOK.MKR Page 27 Tuesday, March 4, 1997 7:24 PM
Vue de la page 88
1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 139 140

Commentaires sur ces manuels

Pas de commentaire