Bay Networks 5391 Guide d'installation télécharger pdf (Page 110)

Remote Annex 2000 Hardware Installation Guide

Chapter 4 Troubleshooting Procedures

4-18

❑ All Remote Annex 2000 software is installed properly on the

host (see the software installation notes that accompany your

software release).

❑ The erpcd daemon or tftp server, which loads the Remote

Annex 2000’s operational code, is running.

A PC host running the UNIX operating system has both the erpcd

and slipd daemons (provided with the distribution and installed in

/etc) running in the background on the PC. Set the Remote Annex

2000 and the erpcd on the load host into test mode:

1 For erpcd on the load server host, as superuser, kill the erpcd

program and restart it using the –D option:

# /usr/annex/erpcd -D5

2 For the Remote Annex 2000, hold down the button until the

Power LED blinks rapidly, then release the button and press it

again within 3 seconds. Then enter:

# boot -v

Another Remote Annex 2000

When troubleshooting a Remote Annex 2000 configured as a load

server host:

1 Use the CLI telnet command to access the unit and verify that it is up

and running.

2 Communicate with the unit using the CLI ping command.

3 Verify the unit’s conﬁguration using the na utility or the local CLI

admin command.

The Remote Annex Administrator’s Guide for UNIX provides more

information on these commands.

A Remote Annex 2000 that has been reconfigured as a load server

host, but not rebooted, cannot boot another Remote Annex 2000 on

the network. Rebooting the Remote Annex 2000 load server host

ensures that the parameters are set.

Test

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 135 136

Pas de commentaire

Bay Networks 5391 Guide d'installation Page 110