Bay Networks 5391 Guide d'installation télécharger pdf (Page 88)

Remote Annex 2000 Hardware Installation Guide

Chapter 3 ROM Monitor Commands

3-30

slip

The slip command defines a serial port as a Serial Line Internet

Protocol (SLIP) interface. This command defines a number of port

parameters. The command syntax is:

slip [–d][port]

Theslip command automatically sets the number of data bits to 8 for

all SLIP interfaces. The number of data bits does not include the start,

stop, or parity bits.

After entering the command, you are prompted for each parameter.

The port is the number of the serial port to be configured with this

command. If you do not enter a port number, you are prompted for

one.

Table 3-2 lists the information for which the slip command

prompts. The slip display looks like this:

monitor:: slip

Line number (1–16)::6

Allow SL/IP on this port? (y/n) [n]::y

Enter local endpoint address [0.0.0.0]::192.9.200.214

Local endpoint address: 192.9.200.214

Enter subnet mask [255.0.0.0]::

Constructed new subnet mask.

Enter remote endpoint address [0.0.0.0]::192.9.200.0

Remote endpoint address: 192.9.200.0

Enter remote load/dump host address [default

192.9.200.88]::

Remote load/dump host address: 192.9.200.88

Should this interface be used for memory dumps? (y/n) [y]::

Enter the baud rate [9600]::38400

Enter the number of stop bits (1,1.5,2) [1]::

Enter the parity (none,even,odd) [none]::

WARNING

1 2 ... 83 84 85 86 87 88 89 90 91 92 93 ... 135 136

Pas de commentaire

Bay Networks 5391 Guide d'installation Page 88