Bay Networks 5391 Guide d'installation télécharger pdf (Page 63)

3-5Remote Annex 2000 Hardware Installation Guide

Chapter 3 ROM Monitor Commands

addr

The addr command displays and sets several Remote Annex 2000

operating parameters (EEPROM values) relevant to IP network

addressing:

❑ Internet address.

❑ Subnet mask.

❑ Broadcast address.

❑ Preferred Load Host address.

❑ Preferred Dump Host address.

❑ Load/Dump Gateway address.

❑ Type of IP Packet encapsulation.

❑ Load Broadcast

Theaddr -d command also displays the unit’s ROM-resident Ethernet

address in hexadecimal notation (see the Remote Annex Administrator’s

Guide for UNIX). The command syntax is:

addr [–d]

If you enter the addr command without the –d argument, the console

prompts you for each Internet address. Enter Internet addresses using

the standard decimal dot notation.

The addr –d command displays the Remote Annex 2000’s Ethernet

address, IP address, subnet mask, broadcast address, preferred load

host address, preferred dump host address, load/dump gateway

address, IP encapsulation type, and Load Broadcast. The addr -d

command cannot be used to make changes to any of the

displayed parameters.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 135 136

Pas de commentaire

Bay Networks 5391 Guide d'installation Page 63